Chemtronics ES1620

Ultrajet All-Way Duster, 8 oz. Can

(Case of 12) Ships HAZMATThis item is classified as a hazardous material and will incur an additional shipping fee.

Ultrajet® All-Way Duster is a new innovative all-way spray duster with the biggest blast to clean anything fast. This compressed gas duster can be sprayed right-side up and upside down emitting a high pressure blast that cleans electronics without scratching delicate surfaces.

  • Nonflammable
  • Highest powered cleaning strength
  • Zero VOC
  • Filtered to 0.2 microns
  • Leaves no residue
  • 100% ultra-pure HFC-134a
  • Safe on plastics
Special Price $239.20 Regular Price $244.08
  • Buy 12 for $236.76
  • Buy 50 for $234.32
  • Buy 100 for $231.88

FAQs

How can I stop a can of "canned air" aerosol duster from freezing up?

This phenomenon occurs due to the expansion of the compressed refrigerant liquid as it dispenses through the aerosol valve and flashes to a gas. If the aerosol is operated for a long period, frost may form on the can because it is freezing the surrounding water vapor from the air. If it is collecting on the material to be cleaned, the operator is dispensing for too long of a period or is dispensing it too close to the material. The frost will evaporate and leave no residue. However, particulate matter blown onto a sensitive surface may cause damage due to the high pressure of the duster if dispensed too closely to that surface.

How do I properly dispose of an erosol can after it is empty?

It may be different state-by-state, so contact your state environmental agency for regional specific regulations. For a general guideline, here is the process according to EPA hazardous waste regulations 40CFR. The can has to be brought to or approach atmospheric pressure to render the can empty. Puncturing is not required, only that it “approach atmospheric pressure”, i.e. empty the can contents until it’s no longer pressurized. This insures that as much contents as is reasonably possible are out of the can. It is then considered “RCRA-empty”. At that point it can be handled as any other waste metal container, generally as scrap metal under the recycling rules. Note that the can is still considered a solid waste at this point (not necessarily hazardous waste).

Is there something I can do with the extension tube (straw) so it doesn't get lost?

The red cap on Chemtronics aerosol products like flux removers, degreasers, and Freeze-It Freeze Spray has a notch on the top. That is engineered for the straw to snap in and hold into place so you don’t loose it. The aerosol trigger sprayers that are common on dusters, freeze sprays, and flux removers, have two ways to store the straw when not in use. The hole at the back of the body of the sprayer is just the right size for the straw to slide into place for storage. The slot below the trigger is also the right size for the straw to snap into place, which also has the advantage of locking the trigger.

*This item is hazardous and will be subject to an additional Hazmat fee.

More Information
PAC Item Code I139875
MFG Part Number ES1620
Brand Chemtronics
Type Duster
Size 8 oz.
You May Also Be Interested In
©Production Automation Corporation. All Rights Reserved.