Wire Dots

Clean up your act when bonding wires. Wire Dots make the job of bonding jumper wires neat and fast.

Wire Dots are a wire tacking system consisting of pre-cut shapes of a thin, flexible polymer film coated on one side with a high performance, electronics grade permanent pressure sensitive adhesive. The result is a highly conformable, high strength bond.

Wire Dots will hold secure after exposure to numerous chemicals including cleaning solutions/sprays, saponifiers, mild acids and alkalies. And will hold secure through a typical circuit board hot water wash.

Features

• Very good initial bond strength that increases over 72 hours to stabilize as a high strength reliable bond.
• High humidity has a minimal effect on adhesive performance.
• Will hold securely after exposure to numerous chemicals including cleaning solutions/sprays, saponifiers, mild acids and alkalies.
• Wires will hold securely through a typical PCB hot water wash.
• Can be repositioned during and immediately after initial bonding without causing adhesive transfer or loss of bond strength.
• Retains its performance and properties for one year from date of purchase when stored at room temperature.